Be the first to ask a question.
The BMP180 precision sensor from Bosch is the best low-cost sensing solution for measuring barometric pressure and temperature. In addition to this, because pressure changes with altitude, you can also use it as an altimeter too! The sensor is soldered onto a PCB with a 3.3V regulator, I2C level shifter and pull-up resistors on the I2C pins.
The BMP180 is the next-generation of sensors from Bosch, and replaces the BMP085. The good news is that it is completely identical to the BMP085 in terms of firmware/software/interfacing - you can use our BMP085 tutorial and any example code/libraries as a drop-in replacement.
This board is 5V compliant - a 3.3V regulator and a i2c level shifter circuit is included so you can use this sensor safely with 5V logic and power.
Using the sensor is easy. For example, if you're using an Arduino, simply connect the VIN pin to the 5V voltage pin, GND to ground, SCL to I2C Clock (Analog 5) and SDA to I2C Data (Analog 4). Then download our BMP085/BMP180 Arduino library and example code for temperature, pressure and altitude calculation. Install the library, and load the example sketch. Immediately you'll have precision temperature, pressure and altitude data. We also have a Detailed tutorial on the Raspberry Pi
so you can understand the sensor in depth including how to properly calculate altitude based on sea-level barometric pressure.
The Adafruit Barometric Pressure Temperature Sensor Features:
- BMP180 Precision Digital Barometer Sensor
- Vin: 3 to 5VDC
- Logic: 3 to 5V Compliant
- Pressure sensing range: 300-1100 hPa (9000m to -500m above sea level)
- Up to 0.03hPa / 0.25m resolution
- -40 to +85°C operational range, +-2°C Temperature Accuracy
- PCB weight: 0.81g
Using the BMP085/180 Breakout Board with the Raspberry Pi
Bosch BMP085/180 Breakout Board
Arduino Library and Example Code