My Account

Wish List (0)

Grove - Screw Terminal

Product Code:MMP-0992

Ex.Tax £4.16

Availability: 9

Grove - Screw Terminal
Questions1 Answers1 | Expand All
How to use
Hi team, am I able to use this to connect two momentary buttons to my GrovePi+? And if so how do I use it? I have the grovePi C library and have everything else working, RGBLCD, LEDs and speaker. There's nothing on Seeeds website/wiki and they still haven't replied to me. Kind regards Martin
Martin Pegler
  • This module as a very generic item... It simply allows you to wire up non-grove items, to be used in the grove system. As the grove system uses I2C you can wire up additional I2C items. 

    Comparing the pin configuration to that of other modules, it looks like D1 would be used for your SCL line, and D2 for the SDA line.

    ModMyPi LTD
    Was this answer helpful? 0
Showing 1 to 1 of 1 (1 pages)

Grove - Screw Terminal with four 3.5mm pitch pins rated up to 6A. Terminal can accept 30 to 20AWG wire. It is most commonly used pitch screw terminal. This Grove has four ports including GND, VCC and two other ports. This Grove can be used to interface Grove wires(signals) with other external non-Grove modules. This Grove acts as a wiring form factor converter.


  • Grove compatible interface
  • 3.5mm pitch pin
  • Accept 30 to 20AWG wire


  • please visit SEEED support pages wiki page for more information about this product. For technical support, please post your questions on our forum.
  • For all Grove users (especially beginners), we provide you guidance PDF documents. Please download and read through Preface - Getting Started and Introduction to Grove before your using of the product.

Write a review


Your Review

Note: HTML is not translated!


Bad           Good

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.