My Account

Wish List (0)

Saved Carts


Approved Re-Seller
Follow us on Facebook! Follow us on Twitter! Follow us on Instagram!


Ryanteck Motor Controller Board

Compatible With:

Raspberry Pi - Model A
Raspberry Pi - Model B
Raspberry Pi - Model B+
Raspberry Pi - Model A+
Raspberry Pi 2 - Model B
Raspberry Pi 3 - Model B
Raspberry Pi Zero
Raspberry Pi 3 - Model B+

Product Code: MMP-0406

Ex.Tax £8.33

This product is currently out of stock. Please enter your details below and we will let you know as soon as it's back in stock!



Ryanteck Motor Controller Board
Ryanteck Motor Controller Board
Ryanteck Motor Controller - Summary Ryanteck Motor Controller - Summary Nov 01, 2017 Ryanteck Motor Controller Board Version 3! The wiring instructions can be found on the page below listed Labelling diagram. The board uses BCM GPIO 17 &am..
Ryanteck Motor Controller - Soldering Guide Ryanteck Motor Controller - Soldering Guide Nov 01, 2017 These are the instructions on how to solder the RTK-000-001 Kit up ready for use. These instructions apply for both the kits on their own and the kits packaged ..
Ryanteck Motor Controller - Wiring Guide Ryanteck Motor Controller - Wiring Guide Nov 01, 2017 At the bottom of the motor controller there are 3 Terminal Blocks. These are labeled: Motor 1 & Motor 2 - These are the motor blocks. In each blo..

The New and improved RTK-000-001-V3 / Motor Controller Board for Raspberry Pi is now pre-soldered and features a new and improved design breaking out the GPIO Pins to the side of the board.

The Ryanteck RPi Motor Controller Board  is a simple to use & budget friendly motor controller board for the Raspberry Pi which allows you to easily control 2 motors in both directions with some simple coding!

Once you receive the board, simply place it on the Raspberry Pi's GPIO header, screw in a power pack, add your motors and then start programming. We officially support Python & Scratch at this point in time although you can use it with any language that allows you to control the GPIO pins including C, Java, PHP, Bash, Node.JS etc. The board uses a SN754410NE IC that enables the use of Software Pulse Width modulation on the Pi, for example using PWM in RPi.GPIO to change the value of speed in Scratch.

Programming the board

As mentioned above, programming the board to drive a motor is as simple as turning a pin on or off. Example code for Python & Scratch will be available soon in the example of a robot. 

The pins used to control the motors are:

Broadcom Pins:

  • Motor 1: 17 & 18
  • Motor 2: 22 & 23

Board Pin Numbers:

  • Motor 1: 11 & 12
  • Motor 2: 15 & 16

Documentation & Resources Website

Visual appearance may vary as shown between the two kit photos, but function remains the same

Reviews about Ryanteck Motor Controller Board
Average rating: 0 reviews
Total reviews: 0
Write your own review on this product.
Write review
Sort By 

Write a review


Your Review:
25-3000 characters
Note: HTML is not translated!

Add prosAdd cons

are you happy?

please confirm the selections below are correct


Foul Language
Other (write below)