Adafruit put a PermaProto half sized proto board in a blender with a Pi Cobbler and out emerged this very tasty confection - the PermaProto for Pi! It has the Cobbler baked right in. Simply solder the 2x13 pin header in and you get all the labeled breakouts with tons of prototyping space, power rails, mounting holes and that gorgeous white silk.
This proto-board is the PCB you always wish you had, but never realized it! Adafruit took the basic layout of a half-sized breadboard (the PCB has 30 rows) and turned that into a beautiful PCB. The top side has a white silkscreen, and the same markings you're familiar with, to make transferring components easy. The bottom has the 5-hole pad design that matches a classic breadboard, with 4 power bus lines on the sides, and no mask so you can easily cut traces when necessary. We used 1.2mm diameter drill holes so even parts with big leads will fit. All holes are thru-plated for strength - these wont peel off with rework. The finish is a gold plate - you won't get oxidation like with bare copper perf! There are also tons of mounting holes so you can attach the PCB to your project box.
The Kit comes with One Small PCB and One Box Header. You'll need to do a little light soldering to attach the box header to the PCB but its fast and easy to do.
To connect it to a Pi, you'll also need a 26-pin GPIO Cable, if you don't already have one.
Ask a Question
Add an Answer
Be the first to ask a question.
Reviews about Adafruit Perma-Proto RPi Breadboard Kit - Small
Total reviews: 0 Write your own review on this product.