My Account

Wish List (0)

ModMyPi - Raspberry Pi T-Cobbler Breakout

Product Code:MMP-0227

£6.95
Ex.Tax £5.79

Out Of Stock

ModMyPi - Raspberry Pi T-Cobbler Breakout
ModMyPi - Raspberry Pi T-Cobbler Breakout
ModMyPi - Raspberry Pi T-Cobbler Breakout
Questions1 Answers1 | Expand All
Length of cable
How long in the ribbon cable?
Craig
  • ~145mm
    ModMyPi LTD
    Was this answer helpful? 1
Showing 1 to 1 of 1 (1 pages)

This neat little prototyping add-on board allows you to transfer those useful GPIO pins from the Raspberry Pi B+2/3 to a breaboard or prototyping project! Simply plug the cobbler into your breadboard and use the included 40 pin ribbon cable to attach the cobbler to your Pi and you're ready to hack! The T-Cobbler takes up less room than the standard cobbler, and also features useful power line headers on either side which can be plumbed in to draw the 3.3V or 5V line directly from the Pi!

If you're looking for a more advanced version, check out our T-Cobbler Pro!

ModMyPi - Raspberry Pi 3 T-Cobbler Breakout Kit Features:
  • Included 40 Pin GPIO Ribbon Cable
  • Included T-Cobbler Printed Circuit Board (PCB)
  • Two 2 x 1 Pin Header Strips for Power Lines (Not Soldered)
  • Fully Labelled Silkscreen for Easy Identification
This kit comes pre assembled so no soldering required!

Write a review

Name

Your Review

Note: HTML is not translated!

Rating

Bad           Good

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.