My Account

Wish List (0)

ModMyPi - Paddle Breakout HAT

Product Code:MMP-0607

Ex.Tax £10.83

Out Of Stock

ModMyPi - Paddle Breakout HAT
ModMyPi - Paddle Breakout HAT
Questions3 Answers3 | Expand All
Does this work with the RPI 3B?
Will this breakout board work properly with s raspberry pi 3 B?
  • Yes, this HAT will work with all Pis that have a 40 pin GPIO
    ModMyPi LTD
    Was this answer helpful? 0
Compatible wire gauge and two more questions
Hi What AWG numbers fit these paddle terminal points? I've got lots of AWG 26 cables which I'd like to use, will this work? Two more questions: 1. What's the difference (apart from the ribbon cable/socket) to the other Paddle Breakout? I wonder why that is about 3.- less in price. 2. Will this product mounted on my Raspberry Pi fit into the HighPi Case (Product Code MMP-0787)? Looking forward to your reply. Best regards.
  • This will happily take 26 AWG wire, we have used 22 AWG with no problems as well.

    1. Main difference is exactly that, the HAT plugs directly on to the Pi. Price increase is due to the header required for this, as well as the additional mounting hardware.

    2. Yes, this will fit the HighPi Case

    ModMyPi LTD
    Was this answer helpful? 0
Suitable ribbon cable
Really useful board! Would like to connect it to my Pi3 with a ribbon cable. Do you know if a standard male 40 pin ribbon cable connector will mate proberly with this board? Or will I need another header? Thanks
Showing 1 to 3 of 3 (1 pages)

The ModMyPi Paddle Breakout HAT enables you to bring the Raspberry Pi GPIO out from your Raspberry Pi to 'push wire' paddle terminal points in the form of a neat HAT! This kit requires absolutely no soldering, but will allow you to jump straight from the Pi to your project or breadboard without the use of a cobbler kit. All terminals are labelled on the PCB silkscreen, and have been re-ordered in a simple to use format.

The 'push wire' terminals can be utilised with solid core wire stripped to around 10mm of exposed copper, which can be purchased from ModMyPi here - Solid Core Prototyping Wire

The ModMyPi Paddle Breakout HAT Features:

  • Fully Labelled Silkscreen for Easy Identification
  • Push Wire Terminals for Quick & Easy Connections
  • Pre-assembled HAT - No Soldering Required
  • Includes 40 Pin HAT Header - Plug & Play
  • Includes M2.5 Stand-Off's for Mounting
  • Manufactured in the UK!

Write a review


Your Review

Note: HTML is not translated!


Bad           Good

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.