My Account

Wish List (0)

Saved Carts

Compare

Approved Re-Seller
Follow us on Facebook! Follow us on Twitter! Follow us on Instagram!

FREE UK DELIVERY ON ORDERS OVER £50 ex.VAT (T&C's APPLY)

Adafruit USB Power Gauge Mini-Kit

Product Code: ADA-1549

£10.00
Ex.Tax £8.33

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name:

Email:

Adafruit USB Power Gauge Mini-Kit
Adafruit USB Power Gauge Mini-Kit
Adafruit USB Power Gauge Mini-Kit

This little USB port go-between is like a speed gauge for your USB devices. Instead of hauling out a multimeter and splicing cables, plug this in between for a quick reading on how much current is being drawn from the port. Great for seeing the charge rate of your phone or tablet, checking your battery chargers, or other USB powered projects.

There are a few USB power meters out there, The Practical Meter and the USB Spypow. We wanted something that was made for makers: Reprogrammable micro-controller, analog output, TTL serial output for debugging / datalogging and of course, open source.

Data is passed through transparently from end to end, so you can use it with any USB device at any speed. The power line has a 0.1 ohm current sense resistor and an INA169 high-side current sensor that is tracked by a little ATtiny85 chip. The microcontroller is programmed to read the current draw as well as the bus voltage and light up the strip of LEDs on the side.

The blue LEDs will light up, one for each Watt of power draw (which is ~200mA at 5V nominal), with a couple levels of PWM dimming for increasing current. You can measure up to 1A of current draw - most USB ports are rated for 500mA. It's safe to use this with something that draws up to 2 A of current, it'll just 'max out' the LEDs.

The green LED is helpful to tell if you have too much droop on your power line. It stays lit as long as the voltage is higher than 4.5V, most devices won't charge effectively once it goes below that so if the green LED goes out, you know you should check your port, shorten the USB cable, or reduce the current draw.

As an awesome extra, we also print out the voltage, current and wattage data as readable text on the TX pin at 9600 baud. Connect an FTDI friend, USB console cable, microcontroller, XBee, whatever you want that can read 9600 baud TTL serial data for datalogging, plotting or display.

Comes as a mini kit with an assembled & tested PCB plus a separate USB jack and plug as shown above. Before use, solder the jack and plug. It'll only take you a few minutes and can be done with any soldering iron. Or, advanced users can splice it between a USB extension cable.

Please note: this is a handy gadget but it isn't a multimeter! We do some basic calibration during test, but the serial output readings are not precise and should be used as a basic guide rather than lab-grade data plots. Assume a variance of at least 0.1V and 50mA due to noise, thermal changes, etc.

Technical Details

  • Dimensions: 17.72mm / 0.69" x 27.09mm / 1.06" x 3.52mm / 0.13"

Source code and schematic at github

Reviews about Adafruit USB Power Gauge Mini-Kit
Average rating: 0 reviews
Total reviews: 0
Write your own review on this product.
Write review
Sort By 

Write a review

Name:


Your Review:
25-3000 characters
Note: HTML is not translated!

Rating:
Overall
Quality
Price
Usability
Add prosAdd cons

are you happy?

please confirm the selections below are correct

YES
CHANGE

Offensive
Foul Language
Irrelevant
Other (write below)