My Account

Wish List (0)

LiPO Battery 4000mAh 3.7V

Product Code:MMP-0060

Ex.Tax £16.66

Availability: 27

LiPO Battery 4000mAh 3.7V
Questions2 Answers2 | Expand All
Is there a datasheet about this item?
How many times can it be cycled? what is the maximum charge current (1C?)? Is it safe to discharge it to its maximum protected discharge level? Did the manufacturer give you any details? Thank you for your help Ben
  • The product description has been updated with this information.
    ModMyPi LTD
    Was this answer helpful? 0
What charger is recommended?
Looking for a module to charge this battery pack. i.e. embed in my project but not clear on my options.
  • This battery is designed to be used with the PIco UPS - - Which will charge the battery as needed. If you are looking for a standalone charger, then you'll need to make sure the charger is designed to charge a single cell LiPo 3.7V up to 4,000mAH
    ModMyPi LTD
    Was this answer helpful? 0
Showing 1 to 2 of 2 (1 pages)

Please Note. Tighter shipping regulations introduced in 2017 relating to the shipping of battery products means that this product can only be shipped to UK and certain EU destinations via DHL ground services - your shipping options will reflect this. For a full list of available Lithium Battery shipping destinations please click here. We cannot ship this product via any air services and, if your country is not listed, we cannot ship this product to you.

3.7V 4000mAh LiPo Battery! Our LiPo batteries come with an embedded PCM (Protection Circuit Module) to protect against over-charging, over-discharging and excessive current draw.

Each battery has an integrated JST XH-2P 2.5mm connector pre-assembled on 40mm of 22AWG wire.

This battery is compatible with the UPS PIco. Simply remove the small default LiPo from the PIco and swap it with this larger version to upgrade and extended the capacity! This will enable prolonged use of a Raspberry Pi in the event of a power loss without a power supply connected!

Technical Specifications:

  • Type: LiPO
  • Voltage: 3.7V
  • Discharge Rating: 1C (Continuous); 2C (Burst)
  • Capacity: 4000mAh
  • Power Rating: 14.8Wh
  • Power Cable Length: 40mm
  • Protection Type: Embedded PCB (Over Charge, Over Discharge, Over Current; 4 ~ 6A Max)
  • Connector: JST XHP-2 (2 Pin x 2.5mm Pitch)
  • Size: 20mm x 52mm x 34mm
  • Weight: 85g
  • Cycle Life: 500
  • Max. Charge Current: 3 ~ 4A (PCM Limited)
  • Min. Protected Discharge Voltage: 3.0V (PCM Limited)

Write a review


Your Review

Note: HTML is not translated!


Bad           Good

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.