My Account

Wish List (0)

Lithium Ion Polymer Battery - 3.7v 500mAh

Product Code:ADA-1578

£11.99
Ex.Tax £9.99

Availability: 10

Lithium Ion Polymer Battery - 3.7v 500mAh
Questions1 Answers1 | Expand All
can these batteries be used in Beebot bugs
We have a charging dock with 6 bugs each bug has a rechargeable battery3.7v 500mah 7530 32 MT5C 130527-04 Will
Jackie Morgan
  • It's hard to say for sure, but yes they will probably work in the Bee Bot, however you will need to take care when charing them.

    These LiPos are designed to be charged at a rate of 1C or less. You will need to check what you charging dock rate is.
    ModMyPi LTD
    Was this answer helpful? 0
Showing 1 to 1 of 1 (1 pages)

Please Note. Tighter shipping regulations introduced in 2017 relating to the shipping of battery products means that this product can only be shipped to UK and certain EU destinations via DHL ground services - your shipping options will reflect this. For a full list of available Lithium Battery shipping destinations please click here. We cannot ship this product via any air services and, if your country is not listed, we cannot ship this product to you.

Lithium ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light and powerful. The output ranges from 4.2V when completely charged to 3.7V. This battery has a capacity of 500mAh for a total of about 1.9 Wh.

The batteries come pre-attached with a genuine 2-pin JST-PH connector as shown and include the necessary protection circuitry. Because they have a genuine JST connector, not a knock-off, the cable wont snag or get stuck in a matching JST jack, they click in and out smoothly.

The included protection circuitry keeps the battery voltage from going too high (over-charging) or low (over-use) which means that the battery will cut-out when completely dead at 3.0V. It will also protect against output shorts. However, even with this protection it is very important that you only use a LiIon/LiPoly constant-voltage/constant-current charger to recharge them and at a rate of 150mA or less. You can also set the Micro Lipo to 500mA rate for a faster charge.

Like most lipos, the batteries we sell do not have thermistors built in. This is why we suggest charging at 1 C or even less - 100 to 500mA is a good rate, and available from any USB port if using a USB-powered charger

Additional safety notes: Do not use a NiMH/NiCad/lead-acid charger! Also, do not abuse these batteries, do not short, bend, crush or puncture. Never charge or use unattended. Always inspect batteries and surrounding circuitry constantly for any damage, loose wiring, or possibility of short circuits. As with all Lithium ion polymer batteries and with any power source - they should be used by experts who are comfortable working with power supplies.

Dimensions: 35mm x 3mm0 x 5mm

Write a review

Name

Your Review

Note: HTML is not translated!

Rating

Bad           Good

Tags: adafruit, lipo, 1578

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.