My Account

Wish List (0)

UPS PIco - JST-XHP-2 Battery Connector (2 Wire)

Product Code:MMP-1122

Ex.Tax £1.00

Availability: 967

UPS PIco - JST-XHP-2 Battery Connector (2 Wire)

Be the first to ask a question.

The UPS PIco features a female XHP-2 connector on board for LiPo battery connections. These JST-XHP-2 cable assembles will allow you to connect 3rd party LiPo's to our UPS PIco

They're 70mm long, feature a 22AWG core on each wire, so plenty thick for most battery loads (max. 8A), and terminate in a male JST XHP-2 on both ends. 

We do not offer warranty on PIco's broken due to the use of a 3rd party batteries disregarding the notes below

Important Notes when using 3rd Party LiPo's with the UPS PIco

  • Check the positive & negative terminals of the LiPo are correct - They are not all the same!
  • LiPo Charging Voltage must be 4.2 V
  • C factor should allow battery to provide more than 6A 
    • e.g. 450mA x 15 (C factor) = 6.75A or 3000 mAh x 2 (C factor) = 6A
  • Larger batteries must have PCM protection installed on battery


  • 2 Pin JST-XHP-2 Assembly (Red/Black)
  • Current rating: 8A AC, DC (AWG #22)
  • Voltage rating: 100V AC, DC
  • 70mm Long
  • Temperature range: -25˚C to +85˚C (including temperature rise in applying electrical current)
  • Contact resistance: Initial value/10m Ω max. After environmental testing/20m Ω max.
  • Insulation resistance: 1,000M Ω min.
  • Withstanding voltage: 800V AC/minute



Write a review


Your Review

Note: HTML is not translated!


Bad           Good

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.