My Account

Wish List (0)

Nwazet Pi Infrared Receiver

Product Code:MMP-0453

£11.99
Ex.Tax £9.99

Availability: 3

Nwazet Pi Infrared Receiver
Nwazet Pi Infrared Receiver
Nwazet Pi Infrared Receiver
Questions1 Answers1 | Expand All
Does this work with the Pi 0W ?
Andrew
  • It does indeed!
    ModMyPi LTD
    Was this answer helpful? 0
Showing 1 to 1 of 1 (1 pages)

This little board plugs right into the Raspberry Pi's GPIO connector and decodes infrared signals sent to it from just about any generic IR remote control. This IR receiver is tuned for a 38kHz carrier frequency but it will accept IR frequencies slightly above or below that at the cost of a reduced range. The IR stream is fed to the Raspberry Pi on GPIO #18, which is the default pin used by the Raspberry Pi's LIRC GPIO driver.

Features:

  • IR decoder: Vishay TSOP75238W
  • Carrier Frequency: 38KHz
  • Transmission Distance: 30m (98.4 feet)
  • Output Current: 5 mA
  • Operating Voltage: 2.5V to 5.5V (3.3V on the Raspberry Pi)
  • Supply Current: 0.35 mA
  • Power Dissipation: 10 mW
  • Maximum Operating Temperature: +85 Celsius
  • Minimum Operating Temperature: -25 Celsius
  • Beam Angle: 75 degrees
  • 0.1" pin header friendly for hacking the Raspberry Pi's GPIO connector

Tutorials

IR Decoder: Vishay TSOP75238W

Linux IR Remote Control

Raspberry Pi LIRC Driver

Write a review

Name

Your Review

Note: HTML is not translated!

Rating

Bad           Good

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.