My Account

Wish List (0)

ADS-B 1090MHz Filtered Preamplifier

Product Code:MMP-1055

£35.99
Ex.Tax £29.99

Out Of Stock

ADS-B 1090MHz Filtered Preamplifier
Questions2 Answers2 | Expand All
Can this be powered from the Pi?
Is the Pi 3Bplus's USB port capable of supplying the required current to power this LNA ?
John
  • Yes, Pi can supply over 1A on the USB. This only requires 56mA
    ModMyPi LTD
    Was this answer helpful? 0
Use with FA Pro Plus
Would this item be a beneficial addition to my current FlightAware Pro Plus (Blue) USB Stick?
Matt
  • This unit simply boosts the signal received by the antenna. If your signal is low/weak then yes this will definitely help!
    ModMyPi LTD
    Was this answer helpful? 0
Showing 1 to 2 of 2 (1 pages)

ADS-B setup need a boost? Look no further than our filtered preamps, designed to improved ADS-B Reception! This SAW based unit is a cost effective solution to give excellent performance gains.

This preamplifier is compatible with most USB SDR Dongles including our FlightAware USB sticks, and many others such as Airspy, Fun Cube etc. You can power them from either bias tee (This item is 100% compatible with the Airspy bias-tee) or a simple mini-USB input using a USB to mini-USB cable (Not Included). Bias tee/USB voltage is 5V max. This filter features female SMA connectors, so you may require an SMA to SMA coupler (or two!) to connect to your devices.

This unit is a small filter and preamp designed to go between a software defined radio receiver and an antenna. Using a SAW or ceramic bandpass filter and a low noise amplifier (LNA), it stops out of band intermodulation while providing additional gain for increased sensitivity. The LNA is before the SAW filter. This particular model is tuned for use with ADS-B frequencies (1090Mhz).

The LNA used is a MiniCircuits PSA4-5043+ which provides at least 16dB of gain @ 1090Mhz. To stop out-of-band intermodulation, a 1090Mhz SAW bandpass filter is fitted. The insertion loss of this filter is approximately 2.3dB, which does increase the overall noise figure of the unit to 0.75dB, which means the overall gain of the unit is at least 14dB. Connectors are SMA female both sides.

Features

  • 1090MHz ADS-B Filtered Preamplifier
  • Connectors SMA Female (Both Sides)
  • Gain: Min 14dB
  • NF 0.75dB
  • Supply Voltage: 5V
  • Current Draw: 56mA approx.
  • Supplied Assembled in Metal Case
  • Dimensions: 63.5mm x 63.5mm x 30mm

Downloads

1090Mhz ADS-B SAW Filter & Preamp For Dongles Datasheet

Write a review

Name

Your Review

Note: HTML is not translated!

Rating

Bad           Good

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.