My Account

Wish List (0)

Adafruit Electret Microphone Amplifier - MAX4466

Product Code:ADA-1063

Ex.Tax £5.83

Availability: 44

Adafruit Electret Microphone Amplifier - MAX4466
Adafruit Electret Microphone Amplifier - MAX4466
Adafruit Electret Microphone Amplifier - MAX4466
Questions1 Answers1 | Expand All
Interfacing with RP3
Which are the pins we can use to interface this microphone amplifier with raspberry pi 3
Showing 1 to 1 of 1 (1 pages)

Did we spell Electric wrong? No! Electret is a dielectric material that has a quasi-permanent electric charge or dipole polarisation (thanks Wikipedia)! But what's it for. . . . ?

The Adafruit Electret Microphone Amplifier can be used to add an ear to your Raspberry Pi project! This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on. For the amplification, it utilises the Maxim MAX4466, an op-amp specifically designed for this delicate task! The amplifier has excellent power supply noise rejection, so this amplifier sounds really good and isn't nearly as noisy or scratchy as other mic amp breakouts we've tried!  This breakout is best used for projects such as voice changers, audio recording, audio sampling, and audio-reactive projects that use FFT.

On the back, there's an integrated small trimmer pot to adjust the gain.You can set the gain from 25x to 125x. That's down to be about 200mVpp (for normal speaking volume about 6" away) which is good for attaching to something that expects 'line level' input without clipping, or up to about 1Vpp, ideal for reading from a microcontroller ADC. The output is rail-to-rail so if the sounds gets loud, the output can go up to 5Vpp!

  • Maxim MX4466 Op-Amp Amplifier
  • Adjustable Gain 25x to 125x
  • 20-20KHz electret microphone Pre-Soldered
  • Excellent low-noise performance
To use, simply connect GND to ground, and VCC to 2.4-5VDC. For the best performance, use the "quietest" supply available (on an Arduino, this would be the 3.3V supply). The audio waveform will come out of the OUT pin. The output will have a DC bias of VCC/2 so when its perfectly quiet, the voltage will be a steady VCC/2 volts (it is DC coupled). If the audio equipment you're using requires AC coupled audio, place a 100uF capacitor between the output pin and the input of your device. If you're connecting to an audio amplifier that has differential inputs or includes decoupling capacitors, the 100uF cap is not required. 
The output pin is not designed to drive speakers or anything but the smallest in-ear headphones - you'll need an audio amplifier if you want to connect the amp directly to speakers. If you're connecting to a microcontroller pin, you don't need an amplifier or decoupling capacitor - connect the OUT pin directly to the microcontroller ADC pin. There's an excellent Audio Amplifier available from ModMyPi here so if you're driving speakers, you'll need one of those too!

Write a review


Your Review

Note: HTML is not translated!


Bad           Good

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.