Raspberry Pi Official Touchscreen USB Power Cable (90 Degree)
Replacement for black/red/yellow/green?
Presume this a straight replacement for all or some of the black/red/yellow/green jumper wires?
- This will replace the red and black pins only. You do not need to worry about the yellow and green wires if you are using a Raspberry Pi Model B+ and aboveWas this answer helpful?
Is it power-only or is it power+data?
- This is power+dataWas this answer helpful?
Showing 1 to 2 of 2 (1 pages)
This 90 degree USB A to 90 degree Micro USB cable is only 10cm long making it perfect for use with the Official Touch Screen to run power from the screen's controller board (USB) to your Raspberry Pi (Micro USB)! With this cable, you can free your Pi's GPIO for other hacking goodness!
It's 24AWG, so thick enough to handle the 2.5A current requirement of the Raspberry Pi 3 without dropping the voltage!
Features:
- 90 Degree USB A Male
- 90 Degree Micro USB B Male
- 10cm Length Including Connectors
- 24AWG Internal Wire for 5V 2.5A
To use, simply plug the USB end of the cable into the touchscreen driver board, and the micro usb cable into the Raspberry Pi's power port. Then plug your power supply into the touchscreen driver board's micro usb port!
