My Account

Wish List (0)

3/8" (9.5mm) M/F Aluminum Standoff Kit (4 Pack)

Product Code:MMP-0334

Ex.Tax £1.24

Availability: 32

3/8" (9.5mm) M/F Aluminum Standoff Kit (4 Pack)
3/8" (9.5mm) M/F Aluminum Standoff Kit (4 Pack)
Questions1 Answers2 | Expand All
Spacer from acrylic case
Hi guys. I'm looking to buy some spacers to mount my pi 3 b+ on. I'm designing an acrylic case and need about 10mm from the case to the bottom of my pi. Do these allow you to spacer below the pi to screw into a case below it? My case will be 3mm thick. Thanks.
  • Great thanks.
    Was this answer helpful? 0
  • One end of the spacer is male and the other end is female. This pack also comes with 6.35mm screws. If you place the spacer female side against your acrylic, then the screws are long enough to go through the acrylic and screw into the spacer holding it in place. To attached the Pi you would then need either some 4-40 nuts, or another female spacer to secure the Pi.
    ModMyPi LTD
    Was this answer helpful? 0
Showing 1 to 1 of 1 (1 pages)

We use these 3/8" Hex M/F standoffs for building custom cases and project enclosures. They are sized (4-40/M3) to fit the mounting points on all revisions of the Raspberry Pi e.g. RPi-2, Model B+, Model B Rev 2 etc.

They can be used by themselves, and provide enough clearance on the underside to comfortably mount a Pi.  They can also be coupled with other standoffs when more clearance is required. These standoffs come complete and ready to fit with matching screws and nuts!


  • 4 x 4-40 x 3/8" Male to Female Aluminum Standoffs (M3 x 9.5mm)
  • 4 x 4-40 x 1/4" Zinc Screws (M3 x 6.35mm)
  • 4 x 4-40 Zinc Nuts (M3)

Write a review


Your Review

Note: HTML is not translated!


Bad           Good

are you happy?

please confirm the selections below are correct

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.