My Account

Wish List (0)

Arcade USB Encoder Wiring Guide

Written by in Tutorials on .

So you've just received your Zero Delay Arcade USB Encoder and its time to wire it up!

Start by getting the USB Encoder PCB board and take note of the connections.

We are going to wire up the Joystick first, so grab that and the ribbon cable.

Plug one end of the ribbon cable into the joystick port, then plug the other end onto the 5 pins on the joystick. Make sure to get the orientation correct, which is white side of the ribbon facing up, towards the red ball on the joystick

Once we've got that sorted, we can start to plug in the button wires. Lets start with the pre-defined buttons. For these we are going to use the blue and white wires.

Then use the white and white wires for the 12 user defined buttons

You can then plug your buttons into these wires. Simply push the female spades connects on the wire, over the male spade connector on the button. Make sure you push down on the button whilst inserting the spade connector, this will make sure you don't accidently deseat the connector.

With all the buttons and joystick wired up, its now just a case of plugging the USB cable

Last update: Aug 01, 2018

Related Products

29 Comments

Leave a Comment

Leave a Reply

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.