My Account

Wish List (0)

RyanTeck Motor Controller RyanTeck Motor Controller Feed


Written by in RyanTeck, RyanTeck Motor Controller on

At the bottom of the motor controller there are 3 Terminal Blocks. These are labeled: Motor 1 & Motor 2 - These are the motor blocks. In each block you can wire one motor into each block. These are Bi-directional so it doesn't matter which side of the motor goes into the pins on the block. The direction is then controlled via code. VCC2 - This is the power in to power the motor controller IC and is the...

0 Comments

Written by in RyanTeck, RyanTeck Motor Controller on

These are the instructions on how to solder the RTK-000-001 Kit up ready for use. These instructions apply for both the kits on their own and the kits packaged with the robots as they are identical. From the 4th of April 2016 all new orders by Ryanteck LTD. include the new Version 3 Board. Tools Required: The following tools are required for assembly: Soldering Iron (30W or above is recommended) with a...

0 Comments

Written by in RyanTeck, RyanTeck Motor Controller on

Ryanteck Motor Controller Board Version 3! The wiring instructions can be found on the page below listed Labelling diagram. The board uses BCM GPIO 17 & 18 for motor 1 and BCM GPIO 22 & 23 for Motor 2. We recommend looking at the latest tutorials for the language you wish to use on how to program. Languages like python have GPIO Zero which has documentation on how to use....

0 Comments

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.