My Account

Wish List (0)

ModMyPi LTD

ModMyPi LTD

Written by in Tutorials on

In this tutorial we will show you how to setup your Raspberry Pi as a WiFi Access Point and how to NAT the access point to your wireless internet connection. If you are looking to connect your access point to the internet over a wired internet connection then check out this tutorial here. We recommend you run through this tutorial with a wired Ethernet connection to make sure you keep an internet connection...

0 Comments

Written by in Tutorials on

In this tutorial we will show you how to setup your Raspberry Pi as a WiFi Access Point and how to bridge the access point to your wired internet connection. If you are looking to connect your access point to the internet over a wifi connection then check out this tutorial here. Let’s start by making sure our Raspbian installation is fully up-to-date sudo apt-get update sudo apt-get upgrade Then we can install the...

0 Comments

Written by in Assembly Instructions on

The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi 3 B+ Raspberry Pi JAM HAT Case 6x Acrylic Pieces 4x M2.5 x 4mm M/F Stand Offs 4x M2.5 x 8mm F/F Stand Offs 4x M2.5 x 14mm M/F Stand Offs 8x M2.5 Black Screws NOTE: Acrylic is a hard and stiff plastic which is sensitive to stress concentrations...

0 Comments

Written by in Tutorials on

In this tutorial, we will show you how you can boot your Raspberry Pi using a USB port instead of the micro-SD card slot! Please note: This method of booting is experimental and is not guaranteed to work with all USB mass storage devices. If you are using a Raspberry Pi 3 – Model B+ or Raspberry Pi 3 – Model A+ then you can skip to the second section of this tutorial “Preparing the...

0 Comments

Written by in Assembly Instructions on

The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi 3 A+ Raspberry Pi PoE HAT Case 6x Acrylic Pieces 4x M2.5 x 4mm M/F Stand Offs 4x M2.5 x 9mm F/F Stand Offs 4x M2.5 x 11mm M/F Stand Offs 8x M2.5 Black Screws NOTE: Acrylic is a hard and stiff plastic which is sensitive to stress concentrations...

0 Comments

Written by in Assembly Instructions on

The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi 3 A+ Raspberry Pi 3 A+ VESA Case 6x Acrylic Pieces 4x M2.5 x 8mm M/F Stand Offs 4x M2.5 x 20mm F/F Stand Offs 8x M2.5 Silver Screws NOTE: Acrylic is a hard and stiff plastic which is sensitive to stress concentrations and shares a certain level of...

0 Comments

Written by in Tutorials on

How to use the TCRT5000 IR line follower sensor with the Raspberry Pi

0 Comments

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.